rtl819xx - Realtek rtl819xx port to OpenWrt

	Commit message (Expand)	Author	Age	Files	Lines
*	ramips: build firmware image for the Planex MZK-W300NH2 Router	juhosg	2012-12-29	1	-0/+20
*	ramips: add user-space support for the Planex MZK-W300NH2 Router	juhosg	2012-12-29	7	-0/+20
*	ramips: rt305x: add kernel support for the Planex MZK-W300NH2 Router	juhosg	2012-12-29	6	-0/+103
*	ramips: build image for Airlive AIR3GII	juhosg	2012-12-29	1	-0/+5
*	ramips: add user-space support for Airlive AIR3GII	juhosg	2012-12-29	5	-0/+10
*	ramips: rt305x: add kernel support for AirLive AIR3GII	juhosg	2012-12-29	6	-1/+106
*	ar71xx: add support for 3.7	juhosg	2012-12-29	98	-0/+9054
*	ar71xx: Build the AP135 images	juhosg	2012-12-29	2	-0/+13
*	ar71xx: Add userspace support for AP135	juhosg	2012-12-29	4	-1/+9
*	ar71xx: Add support for AP135	juhosg	2012-12-29	1	-0/+56
*	ar71xx: use a backported patch to fix AR933x UART baud rate calculation	juhosg	2012-12-29	1	-2/+60
*	ar71xx: change the unaligned access hack to assume an alignment of 2 bytes, s...	nbd	2012-12-28	1	-4/+4
*	mips: use -mno-branch-likely for kernel and userspace, saves ~11k kernel size...	nbd	2012-12-28	6	-4/+26
*	kernel: remove the cisco SIP NAT patch, at least on 3.6 it crashes	nbd	2012-12-27	2	-236/+0
*	brcm47xx: bcma: correct M25P32 serial flash ID	hauke	2012-12-27	1	-0/+11
*	mpc83xx: add support for 3.7	juhosg	2012-12-26	11	-0/+4544
*	mpc83xx: nuke 3.3 support	juhosg	2012-12-26	11	-4548/+0
*	mpc83xx: switch to 3.6.11	juhosg	2012-12-26	1	-1/+1
*	mpc83xx: add support for 3.6	juhosg	2012-12-26	11	-0/+4535
*	mpc83xx: create package for the rbppc_cf module	juhosg	2012-12-26	1	-0/+25
*	generic: more missing symbols for 3.{6,7}	juhosg	2012-12-26	2	-0/+5
*	ar71xx: build image for the AP136-020	juhosg	2012-12-26	1	-1/+2
*	ar71xx: add user-space support for AP136-020	juhosg	2012-12-26	4	-1/+13
*	ar71xx: add kernel support for the AP136-020 board	juhosg	2012-12-26	2	-17/+52
*	ar71xx: rename AP136 to AP136-010	juhosg	2012-12-26	7	-9/+24
*	ar71xx: dynamically set AR8327's PAD configuration on AP136	juhosg	2012-12-25	1	-42/+40
*	generic: ar8216: add sgmii_delay_en field to ar8327_platform_data	juhosg	2012-12-25	3	-0/+5
*	ar71xx: ag71xx: show PHY interface mode in dmesg	juhosg	2012-12-25	1	-2/+24
*	ramips: fix ASUS WL-330N3G MAC address	juhosg	2012-12-24	1	-3/+3
*	ramips: fix wifi EEPROM extraction on DIR-615-Dx models	juhosg	2012-12-24	1	-2/+2
*	[cns3xxx]: add nol2x0 cmdline to disable l2x0 cache	kaloz	2012-12-23	2	-2/+47
*	generic: ar8216: don't use 0 as default VID on AR8327	juhosg	2012-12-22	1	-1/+3
*	generic: more missing symbols for 3.{6,7}	juhosg	2012-12-22	2	-0/+4
*	ramips: unify eeprom file name for the built-in wireless MAC	juhosg	2012-12-22	4	-6/+5
*	ramips: rt3883: fix build error	juhosg	2012-12-22	1	-1/+1
*	ar71xx: register the second ethernet interface on the AP136	juhosg	2012-12-22	2	-5/+27
*	ar71xx: fix ethernet device registration for QCA9558	juhosg	2012-12-22	2	-5/+85
*	ar71xx: rename QCA9558 ETH_CFG bit defines	juhosg	2012-12-22	2	-4/+4
*	ar71xx: fixup allowed PHY interface types for QCA9558	juhosg	2012-12-22	1	-2/+23
*	ar71xx: don't assign any MII bus device on QCA9558 by default	juhosg	2012-12-22	1	-1/+4
*	ar71xx: ag71xx: fix mii_bus_dev sanity check	juhosg	2012-12-22	1	-1/+1
*	ar71xx: ag71xx: don't start/stop built-in switch w/o mii_bus_dev	juhosg	2012-12-22	1	-2/+2
*	generic: ar8316: allow to configure port 6 via platform data on AR8327	juhosg	2012-12-22	2	-17/+19
*	generic: ar8216: rename cpuport_cfg to port0_cfg in ar8327_platform_data	juhosg	2012-12-22	10	-10/+10
*	ramips: add support for 3.7	juhosg	2012-12-22	14	-0/+785
*	ramips: convert to use {e,o}hci-platform driver	juhosg	2012-12-22	8	-525/+98
*	generic/3.6: add platform specific power callbacks to {e,o}hci_platform drivers	juhosg	2012-12-22	4	-0/+305
*	[lantiq] ar9 did not load atm driver properly	blogic	2012-12-22	1	-1/+1
*	[lantiq] dont use input layer for gpio buttons	blogic	2012-12-21	1	-1/+1
*	[lantiq] default switch setup for WBMR	blogic	2012-12-21	1	-0/+6