rtl819xx - Realtek rtl819xx port to OpenWrt

	Commit message (Expand)	Author	Age	Files	Lines
*	ar71xx: ag71xx: fix get_port_link callback	juhosg	2012-03-07	1	-2/+8
*	ar71xx: ag71xx: use the generic get_port_link implementation	juhosg	2012-03-07	1	-66/+0
*	ar71xx: ag71xx: keep VLAN tags if VLAN is not enabled	juhosg	2012-03-01	1	-4/+8
*	ar71xx: ag71xx: add BQL support	juhosg	2012-02-10	1	-5/+13
*	ar71xx: add preliminary support for 3.3	juhosg	2012-02-10	1	-0/+294
*	ar71xx: merge files-3.2 to files	juhosg	2012-02-10	10	-0/+3895
*	ar71xx: move arch specific files to files-2.6.39	juhosg	2012-01-22	10	-3904/+0
*	ar71xx: include linux/module.h in the micrel phy driver	juhosg	2012-01-22	1	-0/+1
*	ar71xx: ag71xx: implement get_port_{link,stats} callbacks	juhosg	2011-12-31	1	-0/+142
*	ar71xx: set a reserved bit that resets to 1 when writing the address table co...	nbd	2011-12-22	1	-0/+2
*	ar71xx: ag71xx: fix switch port setup for AR934X	juhosg	2011-12-15	1	-11/+41
*	ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934X	juhosg	2011-12-15	1	-3/+7
*	ar71xx: ag71xx: setup switch interface mode on AR934X	juhosg	2011-12-15	1	-0/+19
*	ar71xx: ag71xx: detect the built-in switch of the AR934X SoCs	juhosg	2011-12-15	1	-12/+36
*	ar71xx: introduce ar71xx_switch_data	juhosg	2011-12-15	2	-5/+8
*	ar71xx: ag71xx: check PHY IDs before accessing the switch registers	juhosg	2011-12-15	1	-9/+8
*	ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724x	juhosg	2011-12-15	1	-13/+25
*	ar71xx: ag71xx: nuke ar7240sw_init	juhosg	2011-12-15	1	-6/+1
*	ar71xx: ag71xx: add support for getting switch port link status	juhosg	2011-11-13	1	-0/+67
*	ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xx	juhosg	2011-11-13	2	-19/+1
*	ar71xx: ag71xx: remove unused mii_cfg related functions and defines	juhosg	2011-11-13	1	-40/+0
*	ar71xx: set MII interface speed from the set_speed callbacks	juhosg	2011-11-13	1	-6/+0
*	ar71xx: rename set_pll callback to set_speed in ag71xx_platform_data	juhosg	2011-11-13	1	-2/+2
*	ar71xx: ag71xx: remove MII interface setup code	juhosg	2011-11-13	2	-15/+0
*	ar71xx: ag71xx: use fixed link parameters if the mii bus is not registered	juhosg	2011-11-12	1	-0/+4
*	ar71xx: remove dead code	nbd	2011-11-08	1	-15/+0
*	ar71xx: on ar7240, exclude ports from their own port vlan destination mask	nbd	2011-11-08	1	-2/+1
*	ag71xx: close a race between the phy state machine and link state	jogo	2011-10-08	1	-3/+7
*	ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins)	nbd	2011-09-11	1	-1/+1
*	ar71xx: add some code to detect DMA stuck conditions on ar7240	nbd	2011-08-13	2	-1/+33
*	ar71xx: on ar724x only reset the link status in the restart handler, the fast...	nbd	2011-08-13	1	-0/+6
*	ar71xx: fix ethernet FIFO state corruption on ar7240	nbd	2011-08-04	2	-20/+61
*	ag71xx: fix memory corruption issues on ar7240 on ethernet start/stop	nbd	2011-08-04	2	-3/+19
*	ar71xx: fix MAC/MDIO reset mask handling	nbd	2011-08-04	1	-2/+2
*	ar71xx: reinitialize global switch settings after reset on ar7240	nbd	2011-07-20	1	-23/+24
*	ar71xx: configure address aging on ar7240	nbd	2011-07-20	1	-2/+12
*	ar71xx: reset the phy in the ethernet init on ar724x	nbd	2011-07-20	1	-0/+13
*	ar71xx: make sure that rx and interrupts are disabled before issuing the hard...	nbd	2011-07-20	1	-7/+9
*	ar71xx: increase the delay after the ethernet MAC reset	nbd	2011-07-20	1	-1/+1
*	ar71xx: fix an unused variable warning	nbd	2011-07-20	1	-1/+0
*	ar71xx: do not reset the hardware on transmit timeout - this would mess up th...	nbd	2011-07-09	1	-4/+0
*	ag71xx: keep the rx engine stopped while the link is not up, should hopefully...	nbd	2011-07-09	1	-91/+91
*	Revert "ar71xx: only enable the rx engine after the link is up..."	nbd	2011-06-01	1	-68/+67
*	ar71xx: ag71xx: make ring sizes configurable via ethtool	juhosg	2011-05-31	2	-0/+56
*	ar71xx: ag71xx: prepare to make ring sizes configurable	juhosg	2011-05-31	3	-35/+32
*	ar71xx: ag71xx: nuke unused AG71XX_TX_FIFO_LEN define	juhosg	2011-05-31	1	-1/+0
*	ar71xx: only enable the rx engine after the link is up, fixes a race conditio...	nbd	2011-05-30	1	-67/+68
*	ar71xx: disable flow control for ar724x, it can get stuck in a loop of contin...	nbd	2011-05-30	1	-5/+1
*	ar71xx: detect link on LAN ports	matteo	2011-05-17	3	-3/+32
*	use correct macros and frame size in ag71xx	matteo	2011-05-14	1	-3/+2