--- a/arch/arm/mach-at91/Kconfig
+++ b/arch/arm/mach-at91/Kconfig
@@ -354,6 +354,13 @@ config MACH_CPU9G20
 	  Select this if you are using a Eukrea Electromatique's
 	  CPU9G20 Board <http://www.eukrea.com/>
 
+config MACH_NETUS_FOXBOARD
+	bool "Acmesystems NetusG20 board"
+	depends on ARCH_AT91SAM9G20
+	help
+	  Select this if you are using a Acmesystems NetusG20
+	  board <http://netus.acmesystems.it/>
+
 endif
 
 # ----------------------------------------------------------
@@ -444,6 +451,26 @@
 	  On AT91SAM926x boards both types of NAND flash can be present
 	  (8 and 16 bit data bus width).
 
+config NETUS_HEARTBEAT_LED
+	bool "Use heartbeat trigger for led"
+	depends on MACH_NETUS_FOXBOARD
+	help
+	  Select this option to enable default trigger heartbeart for
+	  FoxBoardG20 red led.
+
+config NETUS_SERIALS
+	bool "Enable serials"
+	depends on MACH_NETUS_FOXBOARD
+	help
+	  Select this option to enable serials interface /dev/ttyS1,
+	  /dev/ttyS2 and /dev/ttyS5 (for oLed interface)
+
+config NETUS_USE_DATAFLASH
+	bool "Enable the dataflash"
+	depends on MACH_NETUS_FOXBOARD
+	help
+	  Select this option to use the dataflash.
+
+config NETUS_FOXGM
+	bool "Enable support for FoxGM board"
+	depends on MACH_NETUS_FOXBOARD
+	select LEDS_TRIGGER_HEARTBEAT
+	help
+	  Select this option to auto-configure leds and
+	  serial ports according to FOXGM board.
+
 # ----------------------------------------------------------
 
 comment "AT91 Feature Selections"
--- a/arch/arm/mach-at91/Makefile
+++ b/arch/arm/mach-at91/Makefile
@@ -62,6 +62,7 @@ obj-$(CONFIG_MACH_AT91SAM9RLEK)	+= board
 obj-$(CONFIG_MACH_AT91SAM9G20EK) += board-sam9g20ek.o
 obj-$(CONFIG_MACH_AT91SAM9G20EK_2MMC) += board-sam9g20ek-2slot-mmc.o
 obj-$(CONFIG_MACH_CPU9G20)	+= board-cpu9krea.o
+obj-$(CONFIG_MACH_NETUS_FOXBOARD) += board-netus-foxboard.o
 
 # AT91SAM9G45 board-specific support
 obj-$(CONFIG_MACH_AT91SAM9G45EKES) += board-sam9m10g45ek.o