--- a/drivers/net/wireless/b43/bus.c
+++ b/drivers/net/wireless/b43/bus.c
@@ -107,11 +107,9 @@ struct b43_bus_dev *b43_bus_dev_bcma_ini
 	dev->dma_dev = core->dma_dev;
 	dev->irq = core->irq;
 
-	/*
 	dev->board_vendor = core->bus->boardinfo.vendor;
 	dev->board_type = core->bus->boardinfo.type;
-	dev->board_rev = core->bus->boardinfo.rev;
-	*/
+	dev->board_rev = core->bus->sprom.board_rev;
 
 	dev->chip_id = core->bus->chipinfo.id;
 	dev->chip_rev = core->bus->chipinfo.rev;
@@ -210,7 +208,7 @@ struct b43_bus_dev *b43_bus_dev_ssb_init
 
 	dev->board_vendor = sdev->bus->boardinfo.vendor;
 	dev->board_type = sdev->bus->boardinfo.type;
-	dev->board_rev = sdev->bus->boardinfo.rev;
+	dev->board_rev = sdev->bus->sprom.board_rev;
 
 	dev->chip_id = sdev->bus->chip_id;
 	dev->chip_rev = sdev->bus->chip_rev;
--- a/drivers/net/wireless/b43/dma.c
+++ b/drivers/net/wireless/b43/dma.c
@@ -1109,7 +1109,7 @@ static bool b43_dma_translation_in_low_w
 #ifdef CONFIG_B43_SSB
 	if (dev->dev->bus_type == B43_BUS_SSB &&
 	    dev->dev->sdev->bus->bustype == SSB_BUSTYPE_PCI &&
-	    !(dev->dev->sdev->bus->host_pci->is_pcie &&
+	    !(pci_is_pcie(dev->dev->sdev->bus->host_pci) &&
 	      ssb_read32(dev->dev->sdev, SSB_TMSHIGH) & SSB_TMSHIGH_DMA64))
 			return 1;
 #endif
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -4834,8 +4834,14 @@ static int b43_op_start(struct ieee80211
  out_mutex_unlock:
 	mutex_unlock(&wl->mutex);
 
-	/* reload configuration */
-	b43_op_config(hw, ~0);
+	/*
+	 * Configuration may have been overwritten during initialization.
+	 * Reload the configuration, but only if initialization was
+	 * successful. Reloading the configuration after a failed init
+	 * may hang the system.
+	 */
+	if (!err)
+		b43_op_config(hw, ~0);
 
 	return err;
 }
@@ -5279,10 +5285,10 @@ static void b43_sprom_fixup(struct ssb_b
 
 	/* boardflags workarounds */
 	if (bus->boardinfo.vendor == SSB_BOARDVENDOR_DELL &&
-	    bus->chip_id == 0x4301 && bus->boardinfo.rev == 0x74)
+	    bus->chip_id == 0x4301 && bus->sprom.board_rev == 0x74)
 		bus->sprom.boardflags_lo |= B43_BFL_BTCOEXIST;
 	if (bus->boardinfo.vendor == PCI_VENDOR_ID_APPLE &&
-	    bus->boardinfo.type == 0x4E && bus->boardinfo.rev > 0x40)
+	    bus->boardinfo.type == 0x4E && bus->sprom.board_rev > 0x40)
 		bus->sprom.boardflags_lo |= B43_BFL_PACTRL;
 	if (bus->bustype == SSB_BUSTYPE_PCI) {
 		pdev = bus->host_pci;
--- a/drivers/net/wireless/b43/sdio.c
+++ b/drivers/net/wireless/b43/sdio.c
@@ -193,7 +193,7 @@ static struct sdio_driver b43_sdio_drive
 	.name		= "b43-sdio",
 	.id_table	= b43_sdio_ids,
 	.probe		= b43_sdio_probe,
-	.remove		= b43_sdio_remove,
+	.remove		= __devexit_p(b43_sdio_remove),
 };
 
 int b43_sdio_init(void)
--- a/drivers/net/wireless/b43legacy/main.c
+++ b/drivers/net/wireless/b43legacy/main.c
@@ -1550,8 +1550,6 @@ static void b43legacy_request_firmware(s
 	const char *filename;
 	int err;
 
-	/* do dummy read */
-	ssb_read32(dev->dev, SSB_TMSHIGH);
 	if (!fw->ucode) {
 		if (rev == 2)
 			filename = "ucode2";
@@ -3758,7 +3756,7 @@ static void b43legacy_sprom_fixup(struct
 	/* boardflags workarounds */
 	if (bus->boardinfo.vendor == PCI_VENDOR_ID_APPLE &&
 	    bus->boardinfo.type == 0x4E &&
-	    bus->boardinfo.rev > 0x40)
+	    bus->sprom.board_rev > 0x40)
 		bus->sprom.boardflags_lo |= B43legacy_BFL_PACTRL;
 }
 
--- a/drivers/net/wireless/b43legacy/phy.c
+++ b/drivers/net/wireless/b43legacy/phy.c
@@ -408,7 +408,7 @@ static void b43legacy_phy_setupg(struct
 
 		if (is_bcm_board_vendor(dev) &&
 		    (dev->dev->bus->boardinfo.type == 0x0416) &&
-		    (dev->dev->bus->boardinfo.rev == 0x0017))
+		    (dev->dev->bus->sprom.board_rev == 0x0017))
 			return;
 
 		b43legacy_ilt_write(dev, 0x5001, 0x0002);
@@ -424,7 +424,7 @@ static void b43legacy_phy_setupg(struct
 
 		if (is_bcm_board_vendor(dev) &&
 		    (dev->dev->bus->boardinfo.type == 0x0416) &&
-		    (dev->dev->bus->boardinfo.rev == 0x0017))
+		    (dev->dev->bus->sprom.board_rev == 0x0017))
 			return;
 
 		b43legacy_ilt_write(dev, 0x0401, 0x0002);
--- a/drivers/net/wireless/b43legacy/radio.c
+++ b/drivers/net/wireless/b43legacy/radio.c
@@ -1998,7 +1998,7 @@ u16 b43legacy_default_radio_attenuation(
 			if (phy->type == B43legacy_PHYTYPE_G) {
 				if (is_bcm_board_vendor(dev) &&
 				    dev->dev->bus->boardinfo.type == 0x421 &&
-				    dev->dev->bus->boardinfo.rev >= 30)
+				    dev->dev->bus->sprom.board_rev >= 30)
 					att = 3;
 				else if (is_bcm_board_vendor(dev) &&
 					 dev->dev->bus->boardinfo.type == 0x416)
@@ -2008,7 +2008,7 @@ u16 b43legacy_default_radio_attenuation(
 			} else {
 				if (is_bcm_board_vendor(dev) &&
 				    dev->dev->bus->boardinfo.type == 0x421 &&
-				    dev->dev->bus->boardinfo.rev >= 30)
+				    dev->dev->bus->sprom.board_rev >= 30)
 					att = 7;
 				else
 					att = 6;
@@ -2018,7 +2018,7 @@ u16 b43legacy_default_radio_attenuation(
 			if (phy->type == B43legacy_PHYTYPE_G) {
 				if (is_bcm_board_vendor(dev) &&
 				    dev->dev->bus->boardinfo.type == 0x421 &&
-				    dev->dev->bus->boardinfo.rev >= 30)
+				    dev->dev->bus->sprom.board_rev >= 30)
 					att = 3;
 				else if (is_bcm_board_vendor(dev) &&
 					 dev->dev->bus->boardinfo.type ==
@@ -2052,9 +2052,9 @@ u16 b43legacy_default_radio_attenuation(
 	}
 	if (is_bcm_board_vendor(dev) &&
 	    dev->dev->bus->boardinfo.type == 0x421) {
-		if (dev->dev->bus->boardinfo.rev < 0x43)
+		if (dev->dev->bus->sprom.board_rev < 0x43)
 			att = 2;
-		else if (dev->dev->bus->boardinfo.rev < 0x51)
+		else if (dev->dev->bus->sprom.board_rev < 0x51)
 			att = 3;
 	}
 	if (att == 0xFFFF)