From eb175bb4f21e84f7ca73ba470150793ce1f3ac64 Mon Sep 17 00:00:00 2001 From: florian Date: Mon, 1 Feb 2010 21:11:02 +0000 Subject: [au1000] add 2.6.32 support git-svn-id: svn://svn.openwrt.org/openwrt/trunk@19492 3c298f89-4303-0410-b956-a3cf2f4a3e73 --- .../patches-2.6.32/004-state_led_phy_fix.patch | 31 ++++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch (limited to 'target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch') diff --git a/target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch b/target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch new file mode 100644 index 000000000..cfaea00e2 --- /dev/null +++ b/target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch @@ -0,0 +1,31 @@ +--- a/drivers/net/au1000_eth.c ++++ b/drivers/net/au1000_eth.c +@@ -166,6 +166,15 @@ struct au1000_private *au_macs[NUM_ETH_I + # undef AU1XXX_PHY1_IRQ + #endif + ++#if defined(CONFIG_MIPS_MTX1) ++/* ++ * 4G MeshCube (MTX-1) board ++ * PHY is at address 31 on MAC0 ++ * autodetect fails if not searched for highest address ! ++ */ ++# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR ++#endif ++ + #if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0) + # error MAC0-associated PHY attached 2nd MACs MII bus not supported yet + #endif +@@ -483,6 +492,12 @@ static int mii_probe (struct net_device + aup->old_duplex = -1; + aup->phy_dev = phydev; + ++#ifdef CONFIG_MIPS_MTX1 ++ /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */ ++ printk(KERN_INFO "MTX-1 PHY: updating LED settings\n"); ++ phy_write(phydev, 0x11, 0xff80); ++#endif ++ + printk(KERN_INFO "%s: attached PHY driver [%s] " + "(mii_bus:phy_addr=%s, irq=%d)\n", dev->name, + phydev->drv->name, dev_name(&phydev->dev), phydev->irq); -- cgit v1.2.3