From 7f7d2044e4ec7aad06734ceb824aa74fde29c986 Mon Sep 17 00:00:00 2001 From: nbd Date: Sun, 15 Jun 2008 11:09:27 +0000 Subject: (1/6) bcm57xx: init from diag I've been working to finish up the bcm57xx module package nbd posted a few months ago. I am no expert, just had some spare time and some motivation. Here is the background: https://dev.openwrt.org/ticket/2744 This first patch disables the bcm57xx gpio setup in broadcom-diag. The switch needs to be initialized by the driver so the driver can then reset the switch ASAP. If the switch isn't reset quickly enough, it will forward packets between the WAN and LAN, which will cause problems with modems that only allow one mac to access the internet. Tested on wrt350n. Signed-off-by: Ben Pfountz git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11466 3c298f89-4303-0410-b956-a3cf2f4a3e73 --- package/broadcom-diag/src/diag.c | 3 +++ 1 file changed, 3 insertions(+) (limited to 'package/broadcom-diag') diff --git a/package/broadcom-diag/src/diag.c b/package/broadcom-diag/src/diag.c index a4bad4d00..9cfc1d98c 100644 --- a/package/broadcom-diag/src/diag.c +++ b/package/broadcom-diag/src/diag.c @@ -142,9 +142,12 @@ static void __init bcm4780_init(void) { static void __init bcm57xx_init(void) { int pin = 1 << 2; +#ifndef LINUX_2_4 + /* FIXME: switch comes up, but port mappings/vlans not right */ gpio_outen(pin, pin); gpio_control(pin, 0); gpio_out(pin, pin); +#endif } static struct platform_t __initdata platforms[] = { -- cgit v1.2.3