rtl819xx - Realtek rtl819xx port to OpenWrt

	Commit message (Expand)	Author	Age	Files	Lines
*	[mcs814x] nuport-mac: delay call to napi_start() until fully able to process RX	florian	2012-08-10	1	-2/+2
*	[mcs814x] set a compatible command-line to boot from flash	florian	2012-08-10	1	-1/+1
*	generic: rtl8366_smi: increase delay after switch hw reset	juhosg	2012-08-10	1	-3/+6
*	Fix hard reset of alix/soekris hardware under heavy NIC load	jow	2012-08-09	1	-0/+60
*	[mcs814x] nuport-mac: use dma_mapping_error() instead of checking pointers	florian	2012-08-09	1	-2/+2
*	[mcs814x] nuport-mac: rework PHY interrupt configuration to avoid races	florian	2012-08-08	1	-7/+7
*	[mcs814x] nuport-mac: close possible race condition during start	florian	2012-08-08	1	-1/+5
*	[mcs814x] nuport-mac: unmap the DMA buffer when closing device	florian	2012-08-08	1	-0/+4
*	[mcs814x] nuport-mac: check dma_map_single address return values	florian	2012-08-08	1	-0/+4
*	[mcs814x] build a Devolo dLAN USB Extender specific image	florian	2012-08-08	1	-1/+8
*	[mcs814x] cleanup image generation	florian	2012-08-08	1	-4/+8
*	[lantiq] pci gpio mapping	blogic	2012-08-08	1	-4/+4
*	bcm63xx: fix USB base registers and IRQs for BCM6328	jogo	2012-08-05	10	-12/+100
*	[brcm47xx] update tg3 driver	hauke	2012-08-05	1	-75/+128
*	[brcm47xx] generate image for Linksys e3200	hauke	2012-08-05	1	-0/+1
*	brcm47xx: update gpio patch	hauke	2012-08-05	2	-10/+8
*	brcm47xx: fix patch which moves the flash struct in wgt634u code	hauke	2012-08-05	2	-12/+29
*	[lantiq] W502V/ARV4525 wireless mac bugfix	blogic	2012-08-04	1	-4/+1
*	brcm47xx: use libgpio instaed of implementing the gpio interface ourself.	hauke	2012-08-04	8	-111/+712
*	[lantiq] cleanup patches	blogic	2012-08-03	209	-82080/+146978
*	[mcs814x] nuport-mac: properly protect the phy interrupt handler	florian	2012-08-02	1	-2/+8
*	[bufferbloat] Codel: avoid a nul rec_inv_sqrt	blogic	2012-08-02	1	-0/+68
*	[lantiq] fixes i2c clock enable	blogic	2012-08-02	1	-0/+32
*	ar71xx: simplify misc IRQ handling	juhosg	2012-08-02	1	-0/+66
*	ar71xx: fix AR934X_EHCI_SIZE	juhosg	2012-08-02	4	-4/+4
*	ar71xx: image: stop the switch from the lzma-loader on the TL-WR1043ND	juhosg	2012-08-02	2	-0/+745
*	ar71xx: image: allow to use board specific code in the lzma-loader	juhosg	2012-08-02	3	-3/+10
*	ar71xx: init switch hw_reset on the TL-WR1043ND board	juhosg	2012-08-02	1	-2/+15
*	generic: rtl836x: add hw_reset field to struct rtl8366_smi	juhosg	2012-08-02	7	-2/+35
*	generic: rtl8366_smi: use __rtl8366_smi_cleanup instead of gpio_free calls	juhosg	2012-08-02	1	-2/+1
*	[mcs814x] add missing netmask to the network config	florian	2012-08-01	1	-0/+1
*	[mcs814x] assume the link is up and full-duplex by default	florian	2012-08-01	1	-2/+2
*	[mcs814x] add a default and suitable network config file	florian	2012-08-01	1	-0/+12
*	ar71xx: ew-dorin: added router firmware generation	juhosg	2012-08-01	6	-5/+49
*	ar71xx: ew-dorin: added USB support	juhosg	2012-08-01	1	-1/+3
*	ar71xx: Buffalo WLAE-AG300N wireless led patch	juhosg	2012-08-01	1	-0/+4
*	ar71xx: Buffalo WLAE-AG300N initial support	juhosg	2012-08-01	8	-7/+156
*	[mcs814x] resync defconfig enable XZ compression	florian	2012-08-01	1	-7/+1
*	[mcs814x] properly generate squashfs, jffs2 and initramfs images and kernels	florian	2012-07-31	2	-16/+9
*	[kernel] disable crashlog on ARM platforms for the moment	florian	2012-07-31	1	-1/+1
*	[lantiq] add lantiq svip support	blogic	2012-07-31	22	-53/+17723
*	bcm63xx: Add nb6 support (BCM6362 SoC base boards)	jogo	2012-07-31	10	-6/+191
*	bcm63xx: add basic bcm6362 support	jogo	2012-07-31	18	-14/+1008
*	bcm63xx: enable usb for bcm6328	jogo	2012-07-31	1	-0/+60
*	bcm63xx: update enetswitch driver	jogo	2012-07-31	31	-44/+452
*	bcm63xx: reorder patches	jogo	2012-07-31	13	-17/+17
*	[at91] move i2c module to target modules.mk	florian	2012-07-29	1	-0/+17
*	[omap24xx] resync config	florian	2012-07-29	1	-20/+0
*	[omap24xx] use the same description as other omap platforms (without the dash)	florian	2012-07-29	1	-1/+1
*	[kernel] refresh pwm patch	blogic	2012-07-29	1	-9/+5