| Commit message (Expand) | Author | Age | Files | Lines |
|---|
| * | [brcm63xx] add experimental support for 2.6.28.10, tested on bcm6338 | florian | 2009-07-30 | 2 | -1/+2 |
| * | [brcm63xx] fix typo for the flash start address on bcm6345 | florian | 2009-07-27 | 1 | -1/+1 |
| * | [brcm63xx] fix typos introduced in 16942 | florian | 2009-07-21 | 1 | -2/+2 |
| * | [brcm63xx] make the ethernet driver compile with newer kernels | florian | 2009-07-21 | 1 | -2/+15 |
| * | [brcm63xx] request irq with the platform driver name instead of bus_id which ... | florian | 2009-07-20 | 1 | -1/+1 |
| * | [brcm63xx] register GPIO-connected LEDs for known boards | florian | 2009-07-18 | 2 | -1/+245 |
| * | [brcm63xx] fix comment only valid for bcm6345 | florian | 2009-07-17 | 1 | -1/+1 |
| * | [brcm63xx] add the infrastructure to use a MPI/GPIO connected VoIP DSP | florian | 2009-07-01 | 5 | -1/+97 |
| * | [brcm63xx] fixes for the bcm6338 clocks, thanks Maxime | florian | 2009-07-01 | 1 | -2/+6 |
| * | [brcm63xx] a couple of more fixes to get 6345 booting up to the console handover | florian | 2009-06-30 | 3 | -2/+16 |
| * | [brcm63xx] shared DMA zone is twice smaller on 6338 | florian | 2009-06-28 | 1 | -1/+4 |
| * | [brcm63xx] off-by-one gpio numbers for bcm6338 | florian | 2009-06-28 | 1 | -1/+1 |
| * | [brcm63xx] bcm6338 can support PCI since it has MPI | florian | 2009-06-27 | 1 | -0/+1 |
| * | [brcm63xx] more fixes for bcm6338, no need not to prevent reads from MPI regi... | florian | 2009-06-27 | 3 | -11/+20 |
| * | [brcm63xx] fix the flash address comment and register the flash device again ... | florian | 2009-06-27 | 1 | -3/+7 |
| * | [brcm63xx] fix a stupid typo preventing the board from being detected | florian | 2009-06-27 | 1 | -1/+1 |
| * | [brcm63xx] prevent bcm6338 and bcm6345 from crashing very early | florian | 2009-06-27 | 1 | -3/+9 |
| * | [brcm63xx] only register fallback sprom and enable PCI if we actually have su... | florian | 2009-06-27 | 1 | -2/+4 |
| * | [brcm63xx] more missing register definitions for bcm6338 | florian | 2009-06-27 | 2 | -9/+52 |
| * | [brcm63xx] more bcm6338 and bcm6345 related fixes | florian | 2009-06-26 | 4 | -1/+9 |
| * | [brcm63xx] define bcm6338 SDRAM base register and make sure that the right CP... | florian | 2009-06-26 | 2 | -2/+7 |
| * | [brcm63xx] add board definitions for the bcm6338w | florian | 2009-06-26 | 1 | -0/+8 |
| * | [brcm63xx] add imagetag support for BT Voyager 2500V, patch from Daniel Dicki... | florian | 2009-06-18 | 1 | -1/+1 |
| * | The attached patch adds building of firmware | florian | 2009-06-10 | 2 | -22/+23 |
| * | [brcm63xx] cleanup the watchdog driver a bit | florian | 2009-06-09 | 1 | -10/+10 |
| * | [brcm63xx] fix the watchdog driver and enable it by default | florian | 2009-06-09 | 1 | -110/+129 |
| * | [brcm63xx] rework imagetag firmware generator and MTD partition parser to acc... | florian | 2009-06-09 | 2 | -36/+310 |
| * | [brcm63xx] remove this line which got accidentaly succesfully applied, but sh... | florian | 2009-06-08 | 1 | -2/+0 |
| * | [brcm63xx] fix ethernet driver removal | florian | 2009-06-04 | 1 | -1/+2 |
| * | [brcm63xx] fix pcmcia device removal | florian | 2009-06-04 | 1 | -0/+1 |
| * | [brcm63xx] add missing null entry in pcmcia driver | florian | 2009-06-04 | 1 | -0/+2 |
| * | [brcm63xx] request gpio pins and set direction correctly for pcmcia | florian | 2009-06-04 | 1 | -1/+14 |
| * | [brcm63xx] be SMP safe even with gpiolib | florian | 2009-06-04 | 1 | -7/+8 |
| * | [brcm63xx] cache gpio values in gpio_set | florian | 2009-06-04 | 1 | -5/+8 |
| * | [brcm63xx] use the correct number of GPIOs for bcm6358 | florian | 2009-06-04 | 3 | -6/+12 |
| * | [brcm63xx] register gpiochip earlier, allowing gpio-based runtime detection t... | florian | 2009-06-04 | 3 | -2/+9 |
| * | [brcm63xx] merger mtu/802.1q related fixes: | florian | 2009-06-03 | 2 | -11/+76 |
| * | [brcm63xx] backport an upstream fix: We're not disabling IRQ, so we must call... | florian | 2009-06-01 | 1 | -1/+1 |
| * | [brcm63xx] add support for sysupgrade (#5117) | florian | 2009-05-17 | 1 | -1/+8 |
| * | [brmc63xx] register gpiodev | florian | 2009-04-30 | 1 | -0/+7 |
| * | [brcm63xx] fix redundant driver name printing in probe function | florian | 2009-04-19 | 1 | -1/+1 |
| * | [brcm63xx] make images that can be flashed using the stock firmware web inter... | florian | 2009-04-19 | 1 | -5/+9 |
| * | [brcm63xx] some more fixes to the SPI controller driver | florian | 2009-04-08 | 2 | -29/+31 |
| * | [brcm63xx] enable all blocks on 6338 and uart clock on 6345 | florian | 2009-03-21 | 2 | -1/+10 |
| * | [brcm63xx] add support for bcm6345 SoC, needs testing | florian | 2009-03-20 | 3 | -2/+82 |
| * | [brcm63xx] fix SPI register switch and prepare for UDC, thanks to Henk Vergon... | florian | 2009-03-17 | 9 | -19/+134 |
| * | [brcm63xx] add support for AGPF-S0 (Pirelli Alice Gate VoIP 2 Plus Wi-Fi) #4366 | florian | 2009-03-12 | 1 | -0/+23 |
| * | [brcm63xx] do not duplicate fifo_size, since RX and TX fifo sizes are the sam... | florian | 2009-03-11 | 3 | -17/+17 |
| * | [brcm63xx] make SPI work in full-duplex mode by default | florian | 2009-03-10 | 1 | -2/+2 |
| * | [brcm63xx] add bcm63xx_spi based on reading shared/opensource/flash/spiflash.... | florian | 2009-03-08 | 1 | -0/+439 |
