summaryrefslogtreecommitdiffstats
path: root/target/linux/ar71xx/files
Commit message (Expand)AuthorAgeFilesLines
...
* ar71xx: fix ethernet FIFO state corruption on ar7240nbd2011-08-042-20/+61
* ag71xx: fix memory corruption issues on ar7240 on ethernet start/stopnbd2011-08-042-3/+19
* ar71xx: fix MAC/MDIO reset mask handlingnbd2011-08-041-2/+2
* ar71xx: merge WZR-HP-G301NH support into WZR-HP-G300NHjogo2011-07-282-10/+6
* ar71xx: autodetect rtl8366s/rtl8366rb on wzr-hp-g300nhnbd2011-07-242-13/+8
* rtl8366: unify rtl8366s and rtl8366rb platform datanbd2011-07-245-19/+13
* ar71xx: enable the usb power regulator on the wzr-hp-ag300h through gpio 2 (#...nbd2011-07-241-0/+3
* ar71xx: reinitialize global switch settings after reset on ar7240nbd2011-07-201-23/+24
* ar71xx: configure address aging on ar7240nbd2011-07-201-2/+12
* ar71xx: reset the phy in the ethernet init on ar724xnbd2011-07-202-2/+19
* ar71xx: make sure that rx and interrupts are disabled before issuing the hard...nbd2011-07-201-7/+9
* ar71xx: increase the delay after the ethernet MAC resetnbd2011-07-201-1/+1
* ar71xx: fix an unused variable warningnbd2011-07-201-1/+0
* ar71xx: do not reset the hardware on transmit timeout - this would mess up th...nbd2011-07-091-4/+0
* ag71xx: keep the rx engine stopped while the link is not up, should hopefully...nbd2011-07-091-91/+91
* ar71xx: remove CONFIG_MTD_CONCAT ifdefs from the WZR-HP-AG300H codejuhosg2011-06-301-6/+0
* ar71xx: merge 2.6.39 patchesjuhosg2011-06-294-726/+37
* ar71xx: add 2.6.39 supportjuhosg2011-06-291-0/+688
* ar71xx: remove ar71xx_gpio_irq_set_typejuhosg2011-06-291-11/+0
* ar71xx: add separate handlers for IP3 interruptsjuhosg2011-06-291-5/+39
* ar71xx: use separate handlers for IP2 interruptsjuhosg2011-06-291-20/+48
* ar71xx: remove useless irq_desc.status initializationsjuhosg2011-06-293-13/+4
* ar71xx: bring up secondary radio on wzr-hp-ag300h (fixes #9608)nbd2011-06-251-5/+7
* ar71xx: cleanup AR933X UART driverjuhosg2011-06-192-483/+152
* ar71xx: fix uart clock frequency for AR933Xjuhosg2011-06-191-1/+1
* ar71xx: use ar933x_uart.h in the AR933X serial driverjuhosg2011-06-131-339/+75
* ar71xx: update early_printk codejuhosg2011-06-132-44/+112
* ar71xx: setup wdt_clock for AR913X to avoid a kernel bugjuhosg2011-06-041-0/+2
* ar71xx: select the internal antenna by default on the ZCN-1523H boardsjuhosg2011-06-041-0/+2
* Revert "ar71xx: only enable the rx engine after the link is up..."nbd2011-06-011-68/+67
* ar71xx: init external_reset for AR933Xjuhosg2011-06-012-0/+31
* ar71xx: add external_reset field to ath9k_platform_datajuhosg2011-06-011-0/+1
* ar71xx: init get_mac_revision on AR9330 rev 1juhosg2011-06-011-0/+8
* ar71xx: add get_mac_revision to ath9k_platform_datajuhosg2011-06-011-0/+1
* ar71xx: export SoC revisionjuhosg2011-06-012-0/+6
* ar71xx: add kernel support for the buffalo wzr-hp-ag300hnbd2011-06-014-0/+243
* ar71xx: add support for the AP121/AP121-MINI reference boardsjuhosg2011-05-314-1/+259
* ar71xx: register UART for the AR933X SoCsjuhosg2011-05-311-3/+33
* ar71xx: add serial driver for the AR933X UARTjuhosg2011-05-312-0/+1300
* ar71xx: add WMAC initialization code for the AR933X SoCsjuhosg2011-05-312-0/+16
* ar71xx: add ethernet initialization for the AR933X SoCsjuhosg2011-05-312-0/+64
* ar71xx: enable USB support for the AR933x SoCsjuhosg2011-05-311-0/+2
* ar71xx: add AR933x specific glue for ar71xx_device{start,stop}juhosg2011-05-312-0/+24
* ar71xx: the watchdog uses the reference clock on the AR933x SoCsjuhosg2011-05-311-2/+12
* ar71xx: add AR933x specific glue code for IRQ initializationjuhosg2011-05-312-2/+21
* ar71xx: don't register 8250 UART on the AR933x SoCsjuhosg2011-05-311-1/+6
* ar71xx: enable GPIO support for the AR933x SoCsjuhosg2011-05-312-2/+9
* ar71xx: add AR933x specific frequency initialization codejuhosg2011-05-312-0/+76
* ar71xx: add AR933x specific early_printk supportjuhosg2011-05-312-5/+62
* ar71xx: add preliminary support for the Atheros AR933x SoCsjuhosg2011-05-313-4/+20
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-09 19:39:28 +0000