rtl819xx - Realtek rtl819xx port to OpenWrt

	Commit message (Expand)	Author	Age	Files	Lines
...
*	ar71xx: fix ethernet PLL setting on ar7242	nbd	2011-08-29	1	-3/+5
*	ar71xx: add some code to detect DMA stuck conditions on ar7240	nbd	2011-08-13	4	-1/+36
*	ar71xx: on ar724x only reset the link status in the restart handler, the fast...	nbd	2011-08-13	1	-0/+6
*	ar71xx: adjust the mtd layout of tew-632brp and dir-615c to match the image l...	nbd	2011-08-11	2	-6/+6
*	ar71xx: fix ethernet FIFO state corruption on ar7240	nbd	2011-08-04	2	-20/+61
*	ag71xx: fix memory corruption issues on ar7240 on ethernet start/stop	nbd	2011-08-04	2	-3/+19
*	ar71xx: fix MAC/MDIO reset mask handling	nbd	2011-08-04	1	-2/+2
*	ar71xx: merge WZR-HP-G301NH support into WZR-HP-G300NH	jogo	2011-07-28	2	-10/+6
*	ar71xx: autodetect rtl8366s/rtl8366rb on wzr-hp-g300nh	nbd	2011-07-24	2	-13/+8
*	rtl8366: unify rtl8366s and rtl8366rb platform data	nbd	2011-07-24	5	-19/+13
*	ar71xx: enable the usb power regulator on the wzr-hp-ag300h through gpio 2 (#...	nbd	2011-07-24	1	-0/+3
*	ar71xx: reinitialize global switch settings after reset on ar7240	nbd	2011-07-20	1	-23/+24
*	ar71xx: configure address aging on ar7240	nbd	2011-07-20	1	-2/+12
*	ar71xx: reset the phy in the ethernet init on ar724x	nbd	2011-07-20	2	-2/+19
*	ar71xx: make sure that rx and interrupts are disabled before issuing the hard...	nbd	2011-07-20	1	-7/+9
*	ar71xx: increase the delay after the ethernet MAC reset	nbd	2011-07-20	1	-1/+1
*	ar71xx: fix an unused variable warning	nbd	2011-07-20	1	-1/+0
*	ar71xx: do not reset the hardware on transmit timeout - this would mess up th...	nbd	2011-07-09	1	-4/+0
*	ag71xx: keep the rx engine stopped while the link is not up, should hopefully...	nbd	2011-07-09	1	-91/+91
*	ar71xx: remove CONFIG_MTD_CONCAT ifdefs from the WZR-HP-AG300H code	juhosg	2011-06-30	1	-6/+0
*	ar71xx: merge 2.6.39 patches	juhosg	2011-06-29	4	-726/+37
*	ar71xx: add 2.6.39 support	juhosg	2011-06-29	1	-0/+688
*	ar71xx: remove ar71xx_gpio_irq_set_type	juhosg	2011-06-29	1	-11/+0
*	ar71xx: add separate handlers for IP3 interrupts	juhosg	2011-06-29	1	-5/+39
*	ar71xx: use separate handlers for IP2 interrupts	juhosg	2011-06-29	1	-20/+48
*	ar71xx: remove useless irq_desc.status initializations	juhosg	2011-06-29	3	-13/+4
*	ar71xx: bring up secondary radio on wzr-hp-ag300h (fixes #9608)	nbd	2011-06-25	1	-5/+7
*	ar71xx: cleanup AR933X UART driver	juhosg	2011-06-19	2	-483/+152
*	ar71xx: fix uart clock frequency for AR933X	juhosg	2011-06-19	1	-1/+1
*	ar71xx: use ar933x_uart.h in the AR933X serial driver	juhosg	2011-06-13	1	-339/+75
*	ar71xx: update early_printk code	juhosg	2011-06-13	2	-44/+112
*	ar71xx: setup wdt_clock for AR913X to avoid a kernel bug	juhosg	2011-06-04	1	-0/+2
*	ar71xx: select the internal antenna by default on the ZCN-1523H boards	juhosg	2011-06-04	1	-0/+2
*	Revert "ar71xx: only enable the rx engine after the link is up..."	nbd	2011-06-01	1	-68/+67
*	ar71xx: init external_reset for AR933X	juhosg	2011-06-01	2	-0/+31
*	ar71xx: add external_reset field to ath9k_platform_data	juhosg	2011-06-01	1	-0/+1
*	ar71xx: init get_mac_revision on AR9330 rev 1	juhosg	2011-06-01	1	-0/+8
*	ar71xx: add get_mac_revision to ath9k_platform_data	juhosg	2011-06-01	1	-0/+1
*	ar71xx: export SoC revision	juhosg	2011-06-01	2	-0/+6
*	ar71xx: add kernel support for the buffalo wzr-hp-ag300h	nbd	2011-06-01	4	-0/+243
*	ar71xx: add support for the AP121/AP121-MINI reference boards	juhosg	2011-05-31	4	-1/+259
*	ar71xx: register UART for the AR933X SoCs	juhosg	2011-05-31	1	-3/+33
*	ar71xx: add serial driver for the AR933X UART	juhosg	2011-05-31	2	-0/+1300
*	ar71xx: add WMAC initialization code for the AR933X SoCs	juhosg	2011-05-31	2	-0/+16
*	ar71xx: add ethernet initialization for the AR933X SoCs	juhosg	2011-05-31	2	-0/+64
*	ar71xx: enable USB support for the AR933x SoCs	juhosg	2011-05-31	1	-0/+2
*	ar71xx: add AR933x specific glue for ar71xx_device{start,stop}	juhosg	2011-05-31	2	-0/+24
*	ar71xx: the watchdog uses the reference clock on the AR933x SoCs	juhosg	2011-05-31	1	-2/+12
*	ar71xx: add AR933x specific glue code for IRQ initialization	juhosg	2011-05-31	2	-2/+21
*	ar71xx: don't register 8250 UART on the AR933x SoCs	juhosg	2011-05-31	1	-1/+6