summaryrefslogtreecommitdiffstats
path: root/target/linux/ar71xx/files
Commit message (Expand)AuthorAgeFilesLines
* ar71xx: remove dead codenbd2011-11-081-15/+0
* ar71xx: on ar7240, exclude ports from their own port vlan destination masknbd2011-11-081-2/+1
* ar71xx: add support for the Buffalo WHR-HP-GN boardjuhosg2011-11-072-0/+4
* ar71xx: add support for the Buffalo WHR-G301N boardjuhosg2011-11-072-0/+4
* ar71xx: fix WHR-HP-G300N MTD partitionsjuhosg2011-11-071-1/+2
* ar71xx: add missing AR71XX_MACH_TL_WR741ND_V4juhosg2011-11-011-0/+1
* ar71xx: add initial support for the TL-WR741ND v4 boardjuhosg2011-11-013-0/+165
* ar71xx: add AR933X GMAC register definesjuhosg2011-11-011-0/+19
* ar71xx: unify LED names on Planex boardsjuhosg2011-11-012-11/+11
* ar71xx: unify LED names on Buffalo boardsjuhosg2011-11-013-9/+9
* ar71xx: unify LED names on TP-Link boardsjuhosg2011-11-018-22/+22
* ar71xx: add initial support for the OpenMesh OM2P boardjuhosg2011-10-274-0/+134
* ar71xx/all0258n: fix partition layoutjuhosg2011-10-271-1/+1
* ar71xx: Buffalo WHR-HP-G300N kernel supportjuhosg2011-10-244-0/+181
* ar71xx: add kernel support for the Allnet ALL0258N boardjuhosg2011-10-244-0/+155
* linux: ar71xx: add support for Mikrotik Routerboard RB493Gjogo2011-10-112-0/+63
* ag71xx: close a race between the phy state machine and link statejogo2011-10-081-3/+7
* ar71xx: fix MAC addresses on the DIR-825-B1 boardjuhosg2011-09-231-10/+23
* ar71xx: add support for the TP-Link TL-WR703N v1 boardjuhosg2011-09-214-0/+132
* ar71xx: add AR933x specific USB setup functionjuhosg2011-09-212-2/+25
* ar71xx: add ar71xx_device_reset_rmw helperjuhosg2011-09-212-0/+49
* ar71xx: remove 'default [yn]' from machine Kconfig entriesjuhosg2011-09-211-37/+0
* ar71xx: sort AR71XX_MACH_* entriesjuhosg2011-09-211-16/+16
* ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins)nbd2011-09-111-1/+1
* ar71xx: do not count normal interrupts as spurious (fixes #10037)nbd2011-09-061-1/+2
* ar71xx: fix ethernet PLL setting on ar7242nbd2011-08-291-3/+5
* ar71xx: add some code to detect DMA stuck conditions on ar7240nbd2011-08-134-1/+36
* ar71xx: on ar724x only reset the link status in the restart handler, the fast...nbd2011-08-131-0/+6
* ar71xx: adjust the mtd layout of tew-632brp and dir-615c to match the image l...nbd2011-08-112-6/+6
* ar71xx: fix ethernet FIFO state corruption on ar7240nbd2011-08-042-20/+61
* ag71xx: fix memory corruption issues on ar7240 on ethernet start/stopnbd2011-08-042-3/+19
* ar71xx: fix MAC/MDIO reset mask handlingnbd2011-08-041-2/+2
* ar71xx: merge WZR-HP-G301NH support into WZR-HP-G300NHjogo2011-07-282-10/+6
* ar71xx: autodetect rtl8366s/rtl8366rb on wzr-hp-g300nhnbd2011-07-242-13/+8
* rtl8366: unify rtl8366s and rtl8366rb platform datanbd2011-07-245-19/+13
* ar71xx: enable the usb power regulator on the wzr-hp-ag300h through gpio 2 (#...nbd2011-07-241-0/+3
* ar71xx: reinitialize global switch settings after reset on ar7240nbd2011-07-201-23/+24
* ar71xx: configure address aging on ar7240nbd2011-07-201-2/+12
* ar71xx: reset the phy in the ethernet init on ar724xnbd2011-07-202-2/+19
* ar71xx: make sure that rx and interrupts are disabled before issuing the hard...nbd2011-07-201-7/+9
* ar71xx: increase the delay after the ethernet MAC resetnbd2011-07-201-1/+1
* ar71xx: fix an unused variable warningnbd2011-07-201-1/+0
* ar71xx: do not reset the hardware on transmit timeout - this would mess up th...nbd2011-07-091-4/+0
* ag71xx: keep the rx engine stopped while the link is not up, should hopefully...nbd2011-07-091-91/+91
* ar71xx: remove CONFIG_MTD_CONCAT ifdefs from the WZR-HP-AG300H codejuhosg2011-06-301-6/+0
* ar71xx: merge 2.6.39 patchesjuhosg2011-06-294-726/+37
* ar71xx: add 2.6.39 supportjuhosg2011-06-291-0/+688
* ar71xx: remove ar71xx_gpio_irq_set_typejuhosg2011-06-291-11/+0
* ar71xx: add separate handlers for IP3 interruptsjuhosg2011-06-291-5/+39
* ar71xx: use separate handlers for IP2 interruptsjuhosg2011-06-291-20/+48
generated by cgit v1.2.3 (git 2.25.1) at 2024-12-24 14:17:34 +0000