| Commit message (Expand) | Author | Age | Files | Lines |
... | |
* | ar71xx: ar71xx_spi: save and restore regs from probe/remove | juhosg | 2012-01-11 | 1 | -17/+7 |
* | ar71xx: ar71xx_wdt: add shutdown handler | juhosg | 2012-01-11 | 1 | -0/+6 |
* | ar71xx: fix sections mismatch warnings in the nand drivers | juhosg | 2012-01-05 | 2 | -2/+2 |
* | ar71xx: ag71xx: implement get_port_{link,stats} callbacks | juhosg | 2011-12-31 | 1 | -0/+142 |
* | ar71xx: set a reserved bit that resets to 1 when writing the address table co... | nbd | 2011-12-22 | 1 | -0/+2 |
* | ar71xx: ag71xx: fix switch port setup for AR934X | juhosg | 2011-12-15 | 1 | -11/+41 |
* | ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934X | juhosg | 2011-12-15 | 1 | -3/+7 |
* | ar71xx: ag71xx: setup switch interface mode on AR934X | juhosg | 2011-12-15 | 1 | -0/+19 |
* | ar71xx: ag71xx: detect the built-in switch of the AR934X SoCs | juhosg | 2011-12-15 | 1 | -12/+36 |
* | ar71xx: introduce ar71xx_switch_data | juhosg | 2011-12-15 | 2 | -5/+8 |
* | ar71xx: tplinkpart: allow to detect JFFS2 as well | juhosg | 2011-12-15 | 1 | -3/+4 |
* | ar71xx: ag71xx: check PHY IDs before accessing the switch registers | juhosg | 2011-12-15 | 1 | -9/+8 |
* | ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724x | juhosg | 2011-12-15 | 1 | -13/+25 |
* | ar71xx: ag71xx: nuke ar7240sw_init | juhosg | 2011-12-15 | 1 | -6/+1 |
* | ar71xx: check squashfs signature in TP-Link mtd parser | juhosg | 2011-12-05 | 1 | -1/+31 |
* | ar71xx: add mtd partition parser for the TP-Link boards | juhosg | 2011-12-03 | 1 | -0/+165 |
* | ar71xx: add AR71XX_ prefix to GPIO_REG_* defines | juhosg | 2011-11-14 | 1 | -36/+40 |
* | ar71xx: merge nand scan patch | juhosg | 2011-11-14 | 2 | -2/+2 |
* | ar71xx: ag71xx: add support for getting switch port link status | juhosg | 2011-11-13 | 1 | -0/+67 |
* | ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xx | juhosg | 2011-11-13 | 2 | -19/+1 |
* | ar71xx: ag71xx: remove unused mii_cfg related functions and defines | juhosg | 2011-11-13 | 1 | -40/+0 |
* | ar71xx: set MII interface speed from the set_speed callbacks | juhosg | 2011-11-13 | 1 | -6/+0 |
* | ar71xx: rename set_pll callback to set_speed in ag71xx_platform_data | juhosg | 2011-11-13 | 1 | -2/+2 |
* | ar71xx: ag71xx: remove MII interface setup code | juhosg | 2011-11-13 | 2 | -15/+0 |
* | ar71xx: ag71xx: use fixed link parameters if the mii bus is not registered | juhosg | 2011-11-12 | 1 | -0/+4 |
* | ar71xx: remove dead code | nbd | 2011-11-08 | 1 | -15/+0 |
* | ar71xx: on ar7240, exclude ports from their own port vlan destination mask | nbd | 2011-11-08 | 1 | -2/+1 |
* | ag71xx: close a race between the phy state machine and link state | jogo | 2011-10-08 | 1 | -3/+7 |
* | ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins) | nbd | 2011-09-11 | 1 | -1/+1 |
* | ar71xx: add some code to detect DMA stuck conditions on ar7240 | nbd | 2011-08-13 | 2 | -1/+33 |
* | ar71xx: on ar724x only reset the link status in the restart handler, the fast... | nbd | 2011-08-13 | 1 | -0/+6 |
* | ar71xx: fix ethernet FIFO state corruption on ar7240 | nbd | 2011-08-04 | 2 | -20/+61 |
* | ag71xx: fix memory corruption issues on ar7240 on ethernet start/stop | nbd | 2011-08-04 | 2 | -3/+19 |
* | ar71xx: fix MAC/MDIO reset mask handling | nbd | 2011-08-04 | 1 | -2/+2 |
* | ar71xx: reinitialize global switch settings after reset on ar7240 | nbd | 2011-07-20 | 1 | -23/+24 |
* | ar71xx: configure address aging on ar7240 | nbd | 2011-07-20 | 1 | -2/+12 |
* | ar71xx: reset the phy in the ethernet init on ar724x | nbd | 2011-07-20 | 1 | -0/+13 |
* | ar71xx: make sure that rx and interrupts are disabled before issuing the hard... | nbd | 2011-07-20 | 1 | -7/+9 |
* | ar71xx: increase the delay after the ethernet MAC reset | nbd | 2011-07-20 | 1 | -1/+1 |
* | ar71xx: fix an unused variable warning | nbd | 2011-07-20 | 1 | -1/+0 |
* | ar71xx: do not reset the hardware on transmit timeout - this would mess up th... | nbd | 2011-07-09 | 1 | -4/+0 |
* | ag71xx: keep the rx engine stopped while the link is not up, should hopefully... | nbd | 2011-07-09 | 1 | -91/+91 |
* | ar71xx: merge 2.6.39 patches | juhosg | 2011-06-29 | 1 | -678/+0 |
* | ar71xx: add 2.6.39 support | juhosg | 2011-06-29 | 1 | -0/+688 |
* | ar71xx: cleanup AR933X UART driver | juhosg | 2011-06-19 | 1 | -481/+141 |
* | ar71xx: use ar933x_uart.h in the AR933X serial driver | juhosg | 2011-06-13 | 1 | -339/+75 |
* | ar71xx: setup wdt_clock for AR913X to avoid a kernel bug | juhosg | 2011-06-04 | 1 | -0/+2 |
* | Revert "ar71xx: only enable the rx engine after the link is up..." | nbd | 2011-06-01 | 1 | -68/+67 |
* | ar71xx: add serial driver for the AR933X UART | juhosg | 2011-05-31 | 1 | -0/+1282 |
* | ar71xx: the watchdog uses the reference clock on the AR933x SoCs | juhosg | 2011-05-31 | 1 | -2/+12 |