| Commit message (Expand) | Author | Age | Files | Lines |
* | ar71xx: include linux/module.h in the micrel phy driver | juhosg | 2012-01-22 | 1 | -0/+1 |
* | ar71xx: ag71xx: implement get_port_{link,stats} callbacks | juhosg | 2011-12-31 | 1 | -0/+142 |
* | ar71xx: set a reserved bit that resets to 1 when writing the address table co... | nbd | 2011-12-22 | 1 | -0/+2 |
* | ar71xx: ag71xx: fix switch port setup for AR934X | juhosg | 2011-12-15 | 1 | -11/+41 |
* | ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934X | juhosg | 2011-12-15 | 1 | -3/+7 |
* | ar71xx: ag71xx: setup switch interface mode on AR934X | juhosg | 2011-12-15 | 1 | -0/+19 |
* | ar71xx: ag71xx: detect the built-in switch of the AR934X SoCs | juhosg | 2011-12-15 | 1 | -12/+36 |
* | ar71xx: introduce ar71xx_switch_data | juhosg | 2011-12-15 | 2 | -5/+8 |
* | ar71xx: ag71xx: check PHY IDs before accessing the switch registers | juhosg | 2011-12-15 | 1 | -9/+8 |
* | ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724x | juhosg | 2011-12-15 | 1 | -13/+25 |
* | ar71xx: ag71xx: nuke ar7240sw_init | juhosg | 2011-12-15 | 1 | -6/+1 |
* | ar71xx: ag71xx: add support for getting switch port link status | juhosg | 2011-11-13 | 1 | -0/+67 |
* | ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xx | juhosg | 2011-11-13 | 2 | -19/+1 |
* | ar71xx: ag71xx: remove unused mii_cfg related functions and defines | juhosg | 2011-11-13 | 1 | -40/+0 |
* | ar71xx: set MII interface speed from the set_speed callbacks | juhosg | 2011-11-13 | 1 | -6/+0 |
* | ar71xx: rename set_pll callback to set_speed in ag71xx_platform_data | juhosg | 2011-11-13 | 1 | -2/+2 |
* | ar71xx: ag71xx: remove MII interface setup code | juhosg | 2011-11-13 | 2 | -15/+0 |
* | ar71xx: ag71xx: use fixed link parameters if the mii bus is not registered | juhosg | 2011-11-12 | 1 | -0/+4 |
* | ar71xx: remove dead code | nbd | 2011-11-08 | 1 | -15/+0 |
* | ar71xx: on ar7240, exclude ports from their own port vlan destination mask | nbd | 2011-11-08 | 1 | -2/+1 |
* | ag71xx: close a race between the phy state machine and link state | jogo | 2011-10-08 | 1 | -3/+7 |
* | ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins) | nbd | 2011-09-11 | 1 | -1/+1 |
* | ar71xx: add some code to detect DMA stuck conditions on ar7240 | nbd | 2011-08-13 | 2 | -1/+33 |
* | ar71xx: on ar724x only reset the link status in the restart handler, the fast... | nbd | 2011-08-13 | 1 | -0/+6 |
* | ar71xx: fix ethernet FIFO state corruption on ar7240 | nbd | 2011-08-04 | 2 | -20/+61 |
* | ag71xx: fix memory corruption issues on ar7240 on ethernet start/stop | nbd | 2011-08-04 | 2 | -3/+19 |
* | ar71xx: fix MAC/MDIO reset mask handling | nbd | 2011-08-04 | 1 | -2/+2 |
* | ar71xx: reinitialize global switch settings after reset on ar7240 | nbd | 2011-07-20 | 1 | -23/+24 |
* | ar71xx: configure address aging on ar7240 | nbd | 2011-07-20 | 1 | -2/+12 |
* | ar71xx: reset the phy in the ethernet init on ar724x | nbd | 2011-07-20 | 1 | -0/+13 |
* | ar71xx: make sure that rx and interrupts are disabled before issuing the hard... | nbd | 2011-07-20 | 1 | -7/+9 |
* | ar71xx: increase the delay after the ethernet MAC reset | nbd | 2011-07-20 | 1 | -1/+1 |
* | ar71xx: fix an unused variable warning | nbd | 2011-07-20 | 1 | -1/+0 |
* | ar71xx: do not reset the hardware on transmit timeout - this would mess up th... | nbd | 2011-07-09 | 1 | -4/+0 |
* | ag71xx: keep the rx engine stopped while the link is not up, should hopefully... | nbd | 2011-07-09 | 1 | -91/+91 |
* | Revert "ar71xx: only enable the rx engine after the link is up..." | nbd | 2011-06-01 | 1 | -68/+67 |
* | ar71xx: ag71xx: make ring sizes configurable via ethtool | juhosg | 2011-05-31 | 2 | -0/+56 |
* | ar71xx: ag71xx: prepare to make ring sizes configurable | juhosg | 2011-05-31 | 3 | -35/+32 |
* | ar71xx: ag71xx: nuke unused AG71XX_TX_FIFO_LEN define | juhosg | 2011-05-31 | 1 | -1/+0 |
* | ar71xx: only enable the rx engine after the link is up, fixes a race conditio... | nbd | 2011-05-30 | 1 | -67/+68 |
* | ar71xx: disable flow control for ar724x, it can get stuck in a loop of contin... | nbd | 2011-05-30 | 1 | -5/+1 |
* | ar71xx: detect link on LAN ports | matteo | 2011-05-17 | 3 | -3/+32 |
* | use correct macros and frame size in ag71xx | matteo | 2011-05-14 | 1 | -3/+2 |
* | ar71xx: ag71xx: make switch register access atomic | juhosg | 2011-05-08 | 1 | -6/+8 |
* | ar71xx: ag71xx: fix section mismatch warnings | juhosg | 2011-05-08 | 2 | -2/+2 |
* | ar71xx: ag71xx: fix build error if debugfs is enabled | juhosg | 2011-05-08 | 1 | -2/+3 |
* | ar71xx: ag71xx: add debugfs entry for [rt]x_ring | juhosg | 2011-05-07 | 1 | -0/+92 |
* | ar71xx: ag71xx: add timestamps to ag71xx_buf | juhosg | 2011-05-07 | 2 | -1/+2 |
* | ar71xx: ag71xx: use dynamically allocated buffer for napi_stats | juhosg | 2011-05-07 | 1 | -9/+19 |
* | ar71xx: ag71xx: use debugfs_remove_recursive | juhosg | 2011-05-07 | 2 | -28/+7 |