diff options
Diffstat (limited to 'target/linux/ar71xx/patches-2.6.33')
5 files changed, 87 insertions, 5 deletions
diff --git a/target/linux/ar71xx/patches-2.6.33/150-drivers-link-spi-before-mtd.patch b/target/linux/ar71xx/patches-2.6.33/150-drivers-link-spi-before-mtd.patch new file mode 100644 index 000000000..85a803581 --- /dev/null +++ b/target/linux/ar71xx/patches-2.6.33/150-drivers-link-spi-before-mtd.patch @@ -0,0 +1,12 @@ +--- a/drivers/Makefile ++++ b/drivers/Makefile +@@ -44,8 +44,8 @@ obj-y += macintosh/ + obj-$(CONFIG_IDE) += ide/ + obj-$(CONFIG_SCSI) += scsi/ + obj-$(CONFIG_ATA) += ata/ +-obj-$(CONFIG_MTD) += mtd/ + obj-$(CONFIG_SPI) += spi/ ++obj-$(CONFIG_MTD) += mtd/ + obj-y += net/ + obj-$(CONFIG_ATM) += atm/ + obj-$(CONFIG_FUSION) += message/ diff --git a/target/linux/ar71xx/patches-2.6.33/151-spi-add-various-flags.patch b/target/linux/ar71xx/patches-2.6.33/151-spi-add-various-flags.patch new file mode 100644 index 000000000..bb9a7d6bd --- /dev/null +++ b/target/linux/ar71xx/patches-2.6.33/151-spi-add-various-flags.patch @@ -0,0 +1,19 @@ +--- a/include/linux/spi/spi.h ++++ b/include/linux/spi/spi.h +@@ -434,6 +434,8 @@ struct spi_transfer { + dma_addr_t rx_dma; + + unsigned cs_change:1; ++ unsigned verify:1; ++ unsigned fast_write:1; + u8 bits_per_word; + u16 delay_usecs; + u32 speed_hz; +@@ -475,6 +477,7 @@ struct spi_message { + struct spi_device *spi; + + unsigned is_dma_mapped:1; ++ unsigned fast_read:1; + + /* REVISIT: we might want a flag affecting the behavior of the + * last transfer ... allowing things like "read 16 bit length L" diff --git a/target/linux/ar71xx/patches-2.6.33/152-rb4xx-spi-driver.patch b/target/linux/ar71xx/patches-2.6.33/152-rb4xx-spi-driver.patch new file mode 100644 index 000000000..0eaaace1e --- /dev/null +++ b/target/linux/ar71xx/patches-2.6.33/152-rb4xx-spi-driver.patch @@ -0,0 +1,25 @@ +--- a/drivers/spi/Kconfig ++++ b/drivers/spi/Kconfig +@@ -225,6 +225,12 @@ config SPI_PXA2XX + The driver can be configured to use any SSP port and additional + documentation can be found a Documentation/spi/pxa2xx. + ++config SPI_RB4XX ++ tristate "Mikrotik RB4XX SPI master" ++ depends on SPI_MASTER && AR71XX_MACH_RB4XX ++ help ++ SPI controller driver for the Mikrotik RB4xx series boards. ++ + config SPI_S3C24XX + tristate "Samsung S3C24XX series SPI" + depends on ARCH_S3C2410 && EXPERIMENTAL +--- a/drivers/spi/Makefile ++++ b/drivers/spi/Makefile +@@ -44,6 +44,7 @@ obj-$(CONFIG_SPI_SH_SCI) += spi_sh_sci. + obj-$(CONFIG_SPI_SH_MSIOF) += spi_sh_msiof.o + obj-$(CONFIG_SPI_STMP3XXX) += spi_stmp.o + obj-$(CONFIG_SPI_NUC900) += spi_nuc900.o ++obj-$(CONFIG_SPI_RB4XX) += rb4xx_spi.o + + # special build for s3c24xx spi driver with fiq support + spi_s3c24xx_hw-y := spi_s3c24xx.o diff --git a/target/linux/ar71xx/patches-2.6.33/153-spi-rb4xx-cpld-driver.patch b/target/linux/ar71xx/patches-2.6.33/153-spi-rb4xx-cpld-driver.patch new file mode 100644 index 000000000..1044eb627 --- /dev/null +++ b/target/linux/ar71xx/patches-2.6.33/153-spi-rb4xx-cpld-driver.patch @@ -0,0 +1,26 @@ +--- a/drivers/spi/Kconfig ++++ b/drivers/spi/Kconfig +@@ -363,6 +363,13 @@ config SPI_TLE62X0 + sysfs interface, with each line presented as a kind of GPIO + exposing both switch control and diagnostic feedback. + ++config SPI_RB4XX_CPLD ++ tristate "MikroTik RB4XX CPLD driver" ++ depends on AR71XX_MACH_RB4XX ++ help ++ SPI driver for the Xilinx CPLD chip present on the ++ MikroTik RB4xx boards. ++ + # + # Add new SPI protocol masters in alphabetical order above this line + # +--- a/drivers/spi/Makefile ++++ b/drivers/spi/Makefile +@@ -53,6 +53,7 @@ spi_s3c24xx_hw-$(CONFIG_SPI_S3C24XX_FIQ) + # ... add above this line ... + + # SPI protocol drivers (device/link on bus) ++obj-$(CONFIG_SPI_RB4XX_CPLD) += spi_rb4xx_cpld.o + obj-$(CONFIG_SPI_SPIDEV) += spidev.o + obj-$(CONFIG_SPI_TLE62X0) += tle62x0.o + # ... add above this line ... diff --git a/target/linux/ar71xx/patches-2.6.33/202-spi_vsc7385_driver.patch b/target/linux/ar71xx/patches-2.6.33/202-spi_vsc7385_driver.patch index 487785a94..9885b8b3f 100644 --- a/target/linux/ar71xx/patches-2.6.33/202-spi_vsc7385_driver.patch +++ b/target/linux/ar71xx/patches-2.6.33/202-spi_vsc7385_driver.patch @@ -1,8 +1,8 @@ --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig -@@ -365,6 +365,11 @@ config SPI_TLE62X0 - sysfs interface, with each line presented as a kind of GPIO - exposing both switch control and diagnostic feedback. +@@ -378,6 +378,11 @@ config SPI_RB4XX_CPLD + SPI driver for the Xilinx CPLD chip present on the + MikroTik RB4xx boards. +config SPI_VSC7385 + tristate "Vitesse VSC7385 ethernet switch driver" @@ -14,9 +14,9 @@ # --- a/drivers/spi/Makefile +++ b/drivers/spi/Makefile -@@ -54,6 +54,7 @@ spi_s3c24xx_hw-$(CONFIG_SPI_S3C24XX_FIQ) - +@@ -56,6 +56,7 @@ spi_s3c24xx_hw-$(CONFIG_SPI_S3C24XX_FIQ) # SPI protocol drivers (device/link on bus) + obj-$(CONFIG_SPI_RB4XX_CPLD) += spi_rb4xx_cpld.o obj-$(CONFIG_SPI_SPIDEV) += spidev.o +obj-$(CONFIG_SPI_VSC7385) += spi_vsc7385.o obj-$(CONFIG_SPI_TLE62X0) += tle62x0.o |