diff options
| -rw-r--r-- | target/linux/ar71xx/files/arch/mips/ar71xx/mach-dir-825-b1.c | 33 |
1 files changed, 23 insertions, 10 deletions
diff --git a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-dir-825-b1.c b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-dir-825-b1.c index 25eb26a6f..2393e60b1 100644 --- a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-dir-825-b1.c +++ b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-dir-825-b1.c @@ -1,7 +1,7 @@ /* * D-Link DIR-825 rev. B1 board support * - * Copyright (C) 2009 Lukas Kuna, Evkanet, s.r.o. + * Copyright (C) 2009-2011 Lukas Kuna, Evkanet, s.r.o. * * based on mach-wndr3700.c * @@ -45,8 +45,8 @@ #define DIR825B1_CAL_LOCATION_0 0x1f661000 #define DIR825B1_CAL_LOCATION_1 0x1f665000 -#define DIR825B1_MAC_LOCATION_0 0x2ffa81b8 -#define DIR825B1_MAC_LOCATION_1 0x2ffa8370 +#define DIR825B1_MAC_LOCATION_0 0x1f66ffa0 +#define DIR825B1_MAC_LOCATION_1 0x1f66ffb4 #ifdef CONFIG_MTD_PARTITIONS static struct mtd_partition dir825b1_partitions[] = { @@ -150,20 +150,35 @@ static struct platform_device dir825b1_rtl8366s_device = { } }; +static void dir825b1_read_ascii_mac(u8 *dest, unsigned int src_addr) +{ + int ret; + u8 *src = (u8 *)KSEG1ADDR(src_addr); + + ret = sscanf(src, "%02hhx:%02hhx:%02hhx:%02hhx:%02hhx:%02hhx", + &dest[0], &dest[1], &dest[2], + &dest[3], &dest[4], &dest[5]); + + if (ret != ETH_ALEN) memset(dest, 0, ETH_ALEN); +} + static void __init dir825b1_setup(void) { - u8 *mac = (u8 *) KSEG1ADDR(DIR825B1_MAC_LOCATION_1); + u8 mac1[ETH_ALEN], mac2[ETH_ALEN]; + + dir825b1_read_ascii_mac(mac1, DIR825B1_MAC_LOCATION_0); + dir825b1_read_ascii_mac(mac2, DIR825B1_MAC_LOCATION_1); ar71xx_add_device_mdio(0x0); - ar71xx_init_mac(ar71xx_eth0_data.mac_addr, mac, 1); + ar71xx_init_mac(ar71xx_eth0_data.mac_addr, mac1, 2); ar71xx_eth0_data.mii_bus_dev = &dir825b1_rtl8366s_device.dev; ar71xx_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII; ar71xx_eth0_data.speed = SPEED_1000; ar71xx_eth0_data.duplex = DUPLEX_FULL; ar71xx_eth0_pll_data.pll_1000 = 0x11110000; - ar71xx_init_mac(ar71xx_eth1_data.mac_addr, mac, 2); + ar71xx_init_mac(ar71xx_eth1_data.mac_addr, mac1, 3); ar71xx_eth1_data.mii_bus_dev = &dir825b1_rtl8366s_device.dev; ar71xx_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII; ar71xx_eth1_data.phy_mask = 0x10; @@ -188,10 +203,8 @@ static void __init dir825b1_setup(void) ap94_pci_setup_wmac_led_pin(0, 5); ap94_pci_setup_wmac_led_pin(1, 5); - ap94_pci_init((u8 *) KSEG1ADDR(DIR825B1_CAL_LOCATION_0), - (u8 *) KSEG1ADDR(DIR825B1_MAC_LOCATION_0), - (u8 *) KSEG1ADDR(DIR825B1_CAL_LOCATION_1), - (u8 *) KSEG1ADDR(DIR825B1_MAC_LOCATION_1)); + ap94_pci_init((u8 *) KSEG1ADDR(DIR825B1_CAL_LOCATION_0), mac1, + (u8 *) KSEG1ADDR(DIR825B1_CAL_LOCATION_1), mac2); } MIPS_MACHINE(AR71XX_MACH_DIR_825_B1, "DIR-825-B1", "D-Link DIR-825 rev. B1", |