[au1000] drop support for 2.6.30

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20442 3c298f89-4303-0410-b956-a3cf2f4a3e73

1 files changed, 0 insertions, 31 deletions

diff --git a/target/linux/au1000/patches-2.6.30/004-state_led_phy_fix.patch b/target/linux/au1000/patches-2.6.30/004-state_led_phy_fix.patch
deleted file mode 100644
index cfaea00e2..000000000
--- a/target/linux/au1000/patches-2.6.30/004-state_led_phy_fix.patch
+++ /dev/null
@@ -1,31 +0,0 @@
---- a/drivers/net/au1000_eth.c
-+++ b/drivers/net/au1000_eth.c
-@@ -166,6 +166,15 @@ struct au1000_private *au_macs[NUM_ETH_I
- #  undef AU1XXX_PHY1_IRQ
- #endif
- 
-+#if defined(CONFIG_MIPS_MTX1)
-+/*
-+ * 4G MeshCube (MTX-1) board
-+ * PHY is at address 31 on MAC0
-+ * autodetect fails if not searched for highest address !
-+ */
-+# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
-+#endif
-+
- #if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
- # error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
- #endif
-@@ -483,6 +492,12 @@ static int mii_probe (struct net_device 
- 	aup->old_duplex = -1;
- 	aup->phy_dev = phydev;
- 
-+#ifdef CONFIG_MIPS_MTX1
-+	/* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
-+	printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
-+	phy_write(phydev, 0x11, 0xff80);
-+#endif
-+
- 	printk(KERN_INFO "%s: attached PHY driver [%s] "
- 	       "(mii_bus:phy_addr=%s, irq=%d)\n", dev->name,
- 	       phydev->drv->name, dev_name(&phydev->dev), phydev->irq);