ar71xx: add initial support for 3.2

Tested on the following boards:
  ALFA AP96
  TL-MR3220 v1
  TL-WR1043ND v1
  TL-WR2543ND v1
  TL-WR703N v1
  TL-WR741ND v1
  TL-WR741ND v4
  WNDR3700 v1
  WZR-HP-G300NH

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29868 3c298f89-4303-0410-b956-a3cf2f4a3e73

4 files changed, 194 insertions, 0 deletions

diff --git a/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ag71xx_platform.h b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ag71xx_platform.h
new file mode 100644
index 000000000..43e67557a
--- /dev/null
+++ b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ag71xx_platform.h
@@ -0,0 +1,54 @@
+/*
+ *  Atheros AR71xx SoC specific platform data definitions
+ *
+ *  Copyright (C) 2008-2012 Gabor Juhos <juhosg@openwrt.org>
+ *  Copyright (C) 2008 Imre Kaloz <kaloz@openwrt.org>
+ *
+ *  This program is free software; you can redistribute it and/or modify it
+ *  under the terms of the GNU General Public License version 2 as published
+ *  by the Free Software Foundation.
+ */
+
+#ifndef __ASM_MACH_ATH79_PLATFORM_H
+#define __ASM_MACH_ATH79_PLATFORM_H
+
+#include <linux/if_ether.h>
+#include <linux/skbuff.h>
+#include <linux/phy.h>
+#include <linux/spi/spi.h>
+
+struct ag71xx_switch_platform_data {
+	u8		phy4_mii_en:1;
+};
+
+struct ag71xx_platform_data {
+	phy_interface_t	phy_if_mode;
+	u32		phy_mask;
+	int		speed;
+	int		duplex;
+	u32		reset_bit;
+	u8		mac_addr[ETH_ALEN];
+	struct device	*mii_bus_dev;
+
+	u8		has_gbit:1;
+	u8		is_ar91xx:1;
+	u8		is_ar7240:1;
+	u8		is_ar724x:1;
+	u8		has_ar8216:1;
+
+	struct ag71xx_switch_platform_data *switch_data;
+
+	void		(*ddr_flush)(void);
+	void		(*set_speed)(int speed);
+
+	u32		fifo_cfg1;
+	u32		fifo_cfg2;
+	u32		fifo_cfg3;
+};
+
+struct ag71xx_mdio_platform_data {
+	u32		phy_mask;
+	int		is_ar7240;
+};
+
+#endif /* __ASM_MACH_ATH79_PLATFORM_H */
diff --git a/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ar913x_flash.h b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ar913x_flash.h
new file mode 100644
index 000000000..d19c6b885
--- /dev/null
+++ b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/ar913x_flash.h
@@ -0,0 +1,24 @@
+/*
+ *  AR913x parallel flash driver platform data definitions
+ *
+ *  Copyright (C) 2008-2012 Gabor Juhos <juhosg@openwrt.org>
+ *  Copyright (C) 2008 Imre Kaloz <kaloz@openwrt.org>
+ *
+ *  This program is free software; you can redistribute it and/or modify it
+ *  under the terms of the GNU General Public License version 2 as published
+ *  by the Free Software Foundation.
+ */
+
+#ifndef __AR913X_FLASH_H
+#define __AR913X_FLASH_H
+
+struct mtd_partition;
+
+struct ar913x_flash_platform_data {
+	unsigned int		width;
+	u8			is_shared:1;
+	unsigned int		nr_parts;
+	struct mtd_partition	*parts;
+};
+
+#endif /* __AR913X_FLASH_H */
diff --git a/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/mach-rb750.h b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/mach-rb750.h
new file mode 100644
index 000000000..3e6fc50c5
--- /dev/null
+++ b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/mach-rb750.h
@@ -0,0 +1,68 @@
+/*
+ *  MikroTik RouterBOARD 750 definitions
+ *
+ *  Copyright (C) 2010-2012 Gabor Juhos <juhosg@openwrt.org>
+ *
+ *  This program is free software; you can redistribute it and/or modify it
+ *  under the terms of the GNU General Public License version 2 as published
+ *  by the Free Software Foundation.
+ */
+#ifndef _MACH_RB750_H
+#define _MACH_RB750_H
+
+#include <linux/bitops.h>
+
+#define RB750_GPIO_LVC573_LE	0	/* Latch enable on LVC573 */
+#define RB750_GPIO_NAND_IO0	1	/* NAND I/O 0 */
+#define RB750_GPIO_NAND_IO1	2	/* NAND I/O 1 */
+#define RB750_GPIO_NAND_IO2	3	/* NAND I/O 2 */
+#define RB750_GPIO_NAND_IO3	4	/* NAND I/O 3 */
+#define RB750_GPIO_NAND_IO4	5	/* NAND I/O 4 */
+#define RB750_GPIO_NAND_IO5	6	/* NAND I/O 5 */
+#define RB750_GPIO_NAND_IO6	7	/* NAND I/O 6 */
+#define RB750_GPIO_NAND_IO7	8	/* NAND I/O 7 */
+#define RB750_GPIO_NAND_NCE	11	/* NAND Chip Enable (active low) */
+#define RB750_GPIO_NAND_RDY	12	/* NAND Ready */
+#define RB750_GPIO_NAND_CLE	14	/* NAND Command Latch Enable */
+#define RB750_GPIO_NAND_ALE	15	/* NAND Address Latch Enable */
+#define RB750_GPIO_NAND_NRE	16	/* NAND Read Enable (active low) */
+#define RB750_GPIO_NAND_NWE	17	/* NAND Write Enable (active low) */
+
+#define RB750_GPIO_BTN_RESET	1
+#define RB750_GPIO_SPI_CS0	2
+#define RB750_GPIO_LED_ACT	12
+#define RB750_GPIO_LED_PORT1	13
+#define RB750_GPIO_LED_PORT2	14
+#define RB750_GPIO_LED_PORT3	15
+#define RB750_GPIO_LED_PORT4	16
+#define RB750_GPIO_LED_PORT5	17
+
+#define RB750_LED_ACT		BIT(RB750_GPIO_LED_ACT)
+#define RB750_LED_PORT1		BIT(RB750_GPIO_LED_PORT1)
+#define RB750_LED_PORT2		BIT(RB750_GPIO_LED_PORT2)
+#define RB750_LED_PORT3		BIT(RB750_GPIO_LED_PORT3)
+#define RB750_LED_PORT4		BIT(RB750_GPIO_LED_PORT4)
+#define RB750_LED_PORT5		BIT(RB750_GPIO_LED_PORT5)
+
+#define RB750_LVC573_LE		BIT(RB750_GPIO_LVC573_LE)
+
+#define RB750_LED_BITS	(RB750_LED_PORT1 | RB750_LED_PORT2 | RB750_LED_PORT3 | \
+			 RB750_LED_PORT4 | RB750_LED_PORT5 | RB750_LED_ACT)
+
+struct rb750_led_data {
+	char	*name;
+	char	*default_trigger;
+	u32	mask;
+	int	active_low;
+};
+
+struct rb750_led_platform_data {
+	int			num_leds;
+	struct rb750_led_data	*leds;
+};
+
+int rb750_latch_change(u32 mask_clr, u32 mask_set);
+void rb750_nand_pins_enable(void);
+void rb750_nand_pins_disable(void);
+
+#endif /* _MACH_RB750_H */
\ No newline at end of file
diff --git a/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/rb4xx_cpld.h b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/rb4xx_cpld.h
new file mode 100644
index 000000000..5b17e94b6
--- /dev/null
+++ b/target/linux/ar71xx/files-3.2/arch/mips/include/asm/mach-ath79/rb4xx_cpld.h
@@ -0,0 +1,48 @@
+/*
+ * SPI driver definitions for the CPLD chip on the Mikrotik RB4xx boards
+ *
+ * Copyright (C) 2010 Gabor Juhos <juhosg@openwrt.org>
+ *
+ * This file was based on the patches for Linux 2.6.27.39 published by
+ * MikroTik for their RouterBoard 4xx series devices.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms of the GNU General Public License version 2 as published
+ * by the Free Software Foundation.
+ */
+
+#define CPLD_GPIO_nLED1		0
+#define CPLD_GPIO_nLED2		1
+#define CPLD_GPIO_nLED3		2
+#define CPLD_GPIO_nLED4		3
+#define CPLD_GPIO_FAN		4
+#define CPLD_GPIO_ALE		5
+#define CPLD_GPIO_CLE		6
+#define CPLD_GPIO_nCE		7
+#define CPLD_GPIO_nLED5		8
+
+#define CPLD_NUM_GPIOS		9
+
+#define CPLD_CFG_nLED1		BIT(CPLD_GPIO_nLED1)
+#define CPLD_CFG_nLED2		BIT(CPLD_GPIO_nLED2)
+#define CPLD_CFG_nLED3		BIT(CPLD_GPIO_nLED3)
+#define CPLD_CFG_nLED4		BIT(CPLD_GPIO_nLED4)
+#define CPLD_CFG_FAN		BIT(CPLD_GPIO_FAN)
+#define CPLD_CFG_ALE		BIT(CPLD_GPIO_ALE)
+#define CPLD_CFG_CLE		BIT(CPLD_GPIO_CLE)
+#define CPLD_CFG_nCE		BIT(CPLD_GPIO_nCE)
+#define CPLD_CFG_nLED5		BIT(CPLD_GPIO_nLED5)
+
+struct rb4xx_cpld_platform_data {
+	unsigned	gpio_base;
+};
+
+extern int rb4xx_cpld_change_cfg(unsigned mask, unsigned value);
+extern int rb4xx_cpld_read(unsigned char *rx_buf,
+			   const unsigned char *verify_buf,
+			   unsigned cnt);
+extern int rb4xx_cpld_read_from(unsigned addr,
+				unsigned char *rx_buf,
+				const unsigned char *verify_buf,
+				unsigned cnt);
+extern int rb4xx_cpld_write(const unsigned char *buf, unsigned count);