(6/6) bcm57xx: package

This is the bcm57xx package.  I have tested default vlan functions,
but I dont have the equipment to test more advanced setups.  The default
vlan setup seems to be working fine.  I also added the activate_gpio
parameter which will make the driver activate the switch via gpio before
probing for it.

I'm not sure which method is best for autoload.  For the wrt350n, I
need the activate_gpio parameter.  But its probably not a good idea
to add that to the autoload file.  On a system without a bcm57xx switch,
isn't it a bad idea to mess with the gpios looking for the switch? Ideally,
wouldn't it be best to load the bcm57xx module from broadcom-diag, after
it has determined which router its on?  I tried using 'request_module' from
there, but had no success.  For now, I am relying on preinit to load
the bcm57xx module with activate_gpio param, after it has failed to load
switch_robo and switch_adm.

Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>


git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11471 3c298f89-4303-0410-b956-a3cf2f4a3e73

1 files changed, 20 insertions, 0 deletions

diff --git a/package/broadcom-57xx/src/proto/802.3.h b/package/broadcom-57xx/src/proto/802.3.h
new file mode 100644
index 000000000..493b60e3f
--- /dev/null
+++ b/package/broadcom-57xx/src/proto/802.3.h
@@ -0,0 +1,20 @@
+/*
+ * Copyright 2007, Broadcom Corporation
+ * All Rights Reserved.                
+ *                                     
+ * This is UNPUBLISHED PROPRIETARY SOURCE CODE of Broadcom Corporation;   
+ * the contents of this file may not be disclosed to third parties, copied
+ * or duplicated in any form, in whole or in part, without the prior      
+ * written permission of Broadcom Corporation.                            
+ *
+ * Fundamental constants relating to 802.3
+ *
+ * $Id: 802.3.h,v 1.1.1.1 2007/05/31 08:00:41 michael Exp $
+ */
+
+#ifndef _802_3_h_
+#define _802_3_h_
+
+#define SNAP_HDR_LEN	6	/* 802.3 LLC/SNAP header length */
+
+#endif	/* #ifndef _802_3_h_ */