rtl819xx/target/linux/brcm47xx, branch realtek

kernel: move CONFIG_MIPS_SEAD3 to generic

2013-05-12T21:41:55+00:00

Signed-off-by: Jonas Gorski 

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36617 3c298f89-4303-0410-b956-a3cf2f4a3e73

kernel: update linux 3.8 to 3.8.12

2013-05-08T08:53:53+00:00

Signed-off-by: Gabor Juhos 

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36576 3c298f89-4303-0410-b956-a3cf2f4a3e73

kernel: update linux 3.8 to 3.8.11

2013-05-01T22:15:18+00:00

Signed-off-by: Gabor Juhos 

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36507 3c298f89-4303-0410-b956-a3cf2f4a3e73

broadcom-diag: support for the WNDR3700v3

2013-04-28T21:11:17+00:00

I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it 
was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and
LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the
bootloader and stock firmware will accept.

The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving
its LEDs through an HC164 8-bit shift register.

Signed-off-by: Owen Kirby 


git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36482 3c298f89-4303-0410-b956-a3cf2f4a3e73

brcm47xx: use kernel 3.8.10 as default kernel

2013-04-28T18:25:16+00:00

The biggest change with this kernel is a new partition parser.


git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36480 3c298f89-4303-0410-b956-a3cf2f4a3e73

brcm47xx: add board detection for NETGEAR WNDR4500 V2

2013-04-28T18:19:31+00:00

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36478 3c298f89-4303-0410-b956-a3cf2f4a3e73

kernel: update bcma and ssb for kernel 3.8+ to version from wireless-testing master-2013-04-26.

2013-04-28T16:52:11+00:00

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36473 3c298f89-4303-0410-b956-a3cf2f4a3e73

kernel: update linux 3.8 to 3.8.9

2013-04-26T16:55:42+00:00

Signed-off-by: Gabor Juhos 

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36453 3c298f89-4303-0410-b956-a3cf2f4a3e73

kernel: backport SSB/BCMA changes in preparation for a compat-wireless update

2013-04-19T12:39:40+00:00

Signed-off-by: Felix Fietkau 

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36367 3c298f89-4303-0410-b956-a3cf2f4a3e73

brcm47xx: use old partition names again for kernel 3.8

2013-04-06T22:22:26+00:00

This fixes sysupgrade. The partition names are used all over the Internet in various howtos.

Thank you russell for spotting this problem.


git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36235 3c298f89-4303-0410-b956-a3cf2f4a3e73